Audi A6 2024 - Page 135

4K1012721BA
Driving information
— If the traffic signs are completely or partially
covered, for example by trees, snow, dirt, or
other vehicles
= If traffic signs do not conform to the standard
format
~ If traffic signs are damaged or bent
— If traffic signs are displayed on sign holders
with electronic signs
— If the traffic signs or the roadways have
changed, and the navigation data is no longer
up-to-date
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 126 to page 129.
Under some circumstances, traffic sign rec-
cognition may not detect traffic signs correct-
ly or detect them at all. As a result, the sys-
tem may not display the correct speed limit
or any speed limit.
— Traffic sign recognition only informs and
warns about speed limits. Depending on the
vehicle equipment, additional driver assis-
tance systems can adjust the vehicle speed.
— The display in the instrument cluster is
based on the units of measurement used for
speed in the country where the vehicle is be-
ing operated. As a result, a display of 50 in
the instrument cluster can mean either mph
‘or km/h, depending on the country.
‘Applies to: vehicles with camera-based traffic sign recog
tion
Accessing traffic sign recognition
Depending on the equipment, the vehicle may
have a driver assistance display with or without
area view.
» Without area view: Select in the instrument
cluster: Vehicle functions tab > Traffic signs.
> With area view: Select in the instrument clus-
ter: @ tab.
Setting a traffic sign based speed warning
You can adjust the speed warning threshold to
your preferences in the Driver assistance menu
= page 130. The settings depend on the vehicle
equipment.
Possible settings:
Speed warning - you can select a warning thresh-
old. If you exceed this, then the current detected
speed limit will be shown in the display with an
exclamation point for the duration that it is ex-
ceeded and it will blink for a short time.
Messages
Applies to: vehicles with camera-based traffic sign recogni
tion
displayed when there is a malfunction,
the camera-based traffic sign recognition func-
tions may be unavailable or may be limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors > page 129 and try to turn the system on
again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Faci
ty immediately to have the malfunction correct-
ed.
The following messages may appear depending
on the vehicle equipment:
WI Traffic sign recognition: currently limited.
‘See owner's manual
This message appears if navigation system data
is not available, for example on newly-construct-
ed roads. The speed limit display will be tempo-
rarily limited, which increases the risk of an incor-
rect display.
No traffic sign information available
Depending on the area, there is no valid naviga-
tion data and no speed limits were detected. This
may also appear if there is a recommended
speed, but no speed limit (for example when
driving on and off the expressway).
133
OwnersManuals2.com