ed off.
❑ If the parking brake is
applied with ignition switched off, the lamp lights up for approx. 30 seconds.
❑ The lamp should go out when the parking brake is released.
❑ If the warning lamp flashes continuously after applying the parking brake, the brake force is not sufficient
to prevent the vehicle from accidental movement. Note the following:
❑ If the gradient of the hill is too steep for parking, a warning is displayed. Warning: Vehicle parked too
steep.
❑ In case of malfunction of the parking brake the yellow symbol in the instrument cluster display lights up
additionally and the warning: Parking brake! is displayed.
5 - Left parking brake motor - V282-
❑ Removing and installing ⇒ page 149
❑ Removing and installing control unit for electronic parking brake and handbrake ⇒ page 125
❑ Removing and installing actuator motor for electronic parking brake and handbrake ⇒ page 126
6 - Control unit for electromechanical parking brake - J540-
❑ Installation position: in rear right side panel below tool kit.
❑ Removing and installing ⇒ page 36
7 - Right parking brake motor - V283-
❑ Removing and installing ⇒ page 150
8 - Acoustic signal
❑ Warning signal if parking brake is operated while vehicle is in motion
❑ Warning signal if a fault is detected in the system
11.1 Removing and installing electric park
and handbrake control unit - J540-
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1410-
Removing
– Remove side trim at rear of luggage compartment (right-side)
⇒ Rep. gr. 70 .
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
11. Overview of components - electronic parking brake and handbrake (EPB) 125
To Next Page
Loading...
