Audi A6 Avant 2005 - Removing and Installing Actuator Motor for Electronic Parking Brake and Handbrake

– Unscrew nuts -1-; tightening torque 10 Nm.
– Remove EPB control unit with connection -item 2-.
– Move locking slide -a- in direction of arrow -b- and unplug
connector.
Installing
Install in reverse sequence, paying attention to the following:
– When renewing the control unit, select the function “Replace”
for the relevant control unit in the “Guided Fault Finding”.
Vehicle diagnostic, testing and information system - VAS 5051B-
or -VAS 5052-
11.2 Removing and installing actuator motor
for electronic parking brake and hand‐
brake
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1331-
♦ Vehicle diagnostic, testing and information system - VAS
5051B- or -VAS 5052-
Removing
Note
♦ Ignition on
♦ Release parking brake.
♦ Coding checked and rectified if necessary
♦ Event memory interrogated, indicated faults eliminated and
memory erased.
♦ Ignition off
– Raise vehicle.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
126 Rep. gr.46 - Brakes - mechanism