Audi A6 Avant 2005 - Page 93

Do not leave brake caliper hanging from brake hose but secure it
to bodywork using a suitable cable tie or wire. Take care that
brake hose is not damaged by weight of brake components.
– Remove locating bolt -5- from brake disc, holding brake disc
in position.
– Take brake disc off wheel hub.
Note
Take care to keep the brake disc straight when taking it off the
wheel hub.
Installing
– Clean contact surfaces of wheel hub and remove corrosion.
– Fit brake disc onto wheel hub.
Note
Take care to keep the brake disc straight when fitting it onto the
wheel hub.
– Screw in locating bolt -5- and tighten to 10 Nm.
– Attach brake caliper ⇒ page 78 .
– Install brake pads ⇒ page 81 .
– Fit wheels.
Tightening torque for wheel bolts ⇒ Rep. gr. 44
Caution
Make sure that the brakes work properly before the vehicle is
driven on the road.
Audi A6 2005 ➤ , Audi A6 Avant 2005 ➤
Brake system - Edition 04.2019
4. Front brakes (steel version) - RS 6 87