Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press sizing sleeve -T10133/8- with a slight turning motion
(approximately 180 degrees) onto fuel injector until it stops.
– Pull sizing sleeve -T10133/8- off again, turning it in opposite
direction.
– Moisten new O-ring 3 with clean engine oil before installing.
Note
The combustion chamber seal must not be oiled.
– Slide fuel injector into bore cylinder head as far as stop using
assembly drift -T10133/9- .
Note
The fuel injector must not be difficult to install. If necessary, wait
as the combustion chamber seal continues to pull itself together.
– Make sure fuel injectors are correctly positioned in cylinder
head.
• The electrical connection of fuel injector must engage in in‐
tended recess of cylinder head.
Further installation is in reverse order of removal, note the fol‐
lowing:
– Install intake manifold lower-part ⇒ page 32 .
– Install intake manifold upper-part ⇒ page 29 .
5.5 High Pressure Pump
Special tools and workshop equipment required
♦ Socket 14 mm -3150-
♦ Torque wrench -V.A.G 1331-
♦ Ratchet -V.A.G 1331/1-
♦ Socket -T40055-
Removing
WARNING
♦ Fuel system is under high pressure! Before opening high
pressure components of the fuel injection system, pressure
must be relieved to residual pressure ⇒ page 2 .
♦ Then wrap a clean rag around the connection and relieve
residual pressure by carefully loosening the connection.
– Drain coolant ⇒ Engine Mechanical; Rep. Gr. 19 ; General
Information .
– Remove front coolant pipe ⇒ Engine Mechanical; Rep. Gr.
19 ; Removal and Installation .
– Remove upper part of intake manifold ⇒ page 29 .
Audi A6 2005 ➤
Fuel Injection and Ignition - Edition 03.2008
38 Rep. Gr.24 - Fuel injection system
To Next Page
Loading...
