Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Detach retaining clip -arrow- for wiring harness connector and
push connector inwards.
– Remove wiring harness.
Installing
Installation is carried out in reverse sequence; note the following:
Gearbox with 24 bolts on oil pan
– Carefully attach connector -C- to socket -D- on mechatronic
unit.
– Clip wiring harness -A- onto mechatronic unit -B-. To do so,
first attach tab -arrow- on reverse side of wiring harness to
mechatronic unit.
– Install mechatronic unit
⇒ „1.3 Removing and installing mechatronic unit - gearbox with
24 bolts on oil pan“, page 99 .
Gearbox with 13 bolts on oil pan
– Renew O-rings on connector for wiring harness and lightly lu‐
bricate with ATF.
– Install wiring harness connector in gearbox housing.
• Lugs -1- and -2- on collar are horizontal, flat section -arrow- of
connector faces inside of gearbox.
– Push retainer clip -arrow- onto wiring harness connector.
– Install mechatronic unit
⇒ „1.4 Removing and installing mechatronic unit - gearbox with
13 bolts on oil pan“, page 102 .
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
106 Rep. gr.38 - Gears, control
To Next Page
Loading...
