Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2 Dismantling and assembling ATF
supply unit
Overview
♦ ⇒ „2.1 ATF supply unit - exploded view“, page 108
♦ ⇒ „2.2 Renewing oil seal for torque converter“, page 109
♦ ⇒ „2.3 Removing and installing ATF supply unit“, page 111
♦ ⇒ „2.4 Removing and installing ATF pump in ATF supply unit“,
page 122
♦ ⇒ „2.5 Removing and installing needle bearing for torque con‐
verter“, page 124
2.1 ATF supply unit - exploded view
Note
♦
Some of the components shown are supplied as part of an assembly group and cannot be ordered as
separate components ⇒ Electronic parts catalogue .
♦
Check the individual components of ATF supply unit for traces of wear and damage ⇒ page 178 .
1 - Oil seal for torque converter
❑ Renewing ⇒ page 109
2 - Circlip
3 - Needle bearing for torque
converter
❑ Removing and installing
⇒ page 124
4 - O-ring
❑ Renew
5 - ATF pump housing
❑ Removing and installing
⇒ page 122
6 - Annulus
❑ Note correct position:
dots face upwards
7 - ATF pump gear
❑ Note correct position:
dots face upwards
8 - O-ring
❑ Renew
9 - ATF supply unit
❑ Housing (top section)
❑ Removing and installing
⇒ page 111
10 - ATF supply unit
❑ Housing (bottom sec‐
tion)
❑ Removing and installing
⇒ page 111
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
108 Rep. gr.38 - Gears, control
To Next Page
Loading...
