Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
11 - Bolt
❑ 10 Nm
12 - Stator shaft
❑ Component part of ATF supply unit; cannot be renewed separately
❑ Removing and installing ⇒ „2.3 Removing and installing ATF supply unit“, page 111
13 - Bolt
❑ 10 Nm
14 - Rectangular section seals for ATF supply unit
❑ Renew
2.2 Renewing oil seal for torque converter
Procedure
– Secure gearbox to assembly stand ⇒ page 18 .
– Remove bolts -arrows- on mounting bracket for flange shaft
(left-side).
Caution
While pulling out the flange shaft (left-side), it must be held
centrally to avoid damaging the oil seal between the final drive
and the gearbox housing.
– Pull flange shaft -A- (left-side) out of gearbox, making sure that
shaft remains centered in opening at differential -arrow-.
– Remove torque converter.
– Pry out oil seal for torque converter using oil seal extractor
lever -VW 681- .
– Lightly lubricate outer circumference and sealing lips of oil seal
with ATF.
• Open side of torque converter oil seal faces gearbox.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
2. Dismantling and assembling ATF supply unit 109
To Next Page
Loading...
