Audi A6 - Removing and Installing Needle Bearing for Torque Converter

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.5 Removing and installing needle bearing
for torque converter
Removing
– Remove ATF pump ⇒ page 122 .
– Pry out torque converter oil seal using extractor tool -
T20143/2- .
– Remove circlip -2- from ATF pump housing -1-.
Note
♦ The needle bearing for the torque converter cannot be re‐
moved without being damaged.
♦ Take care not to damage the ATF pump housing when driving
out the needle bearing.
– Turn ATF pump housing upside down and drive out needle
bearing for torque converter using a suitable punch -arrow-.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
124 Rep. gr.38 - Gears, control