Audi A6 - Removing and Installing Flange Shaft (Right-Side) with Gearbox Removed

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
9 - Bolt
❑ Note tightening torque
and sequence ⇒ page 127
10 - Cover for front final drive
❑ Removing and installing ⇒ page 134
11 - Shim
❑ Behind tapered roller bearing outer race
12 - Tapered roller bearing outer race
13 - O-ring for front final drive cover
❑ ⇒ „1.6 Renewing O-ring on cover for front final drive“, page 134
14 - Differential
15 - Roll pin
16 - Gearbox selector lever
17 - Oil seal for selector shaft
❑ Renewing ⇒ page 155
18 - Bolt
❑ 23 Nm
19 - Flange shaft (left-side)
❑ ⇒ „1.3 Removing and installing flange shaft (left-side)“, page 128
Cover for front final drive - tightening torque and sequence:
– Tighten bolts of cover for front final drive as follows.
Stage Tightening sequence
1 – Tighten bolts -1- and -2- to 3 Nm.
2 – Tighten bolts -1 ... 11- to 23 Nm in the sequence
indicated.
1.2 Removing and installing flange shaft
(right-side) with gearbox removed
Special tools and workshop equipment required
♦ Used oil collection and extraction unit -V.A.G 1782-
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
1. Servicing front final drive 127