Audi A6 - Page 170

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Checking inner surfaces of cylinder „C/D“ for scoring by friction
plates
– Check inner surfaces of cylinder „C/D“ for scoring by friction
plates.
• The friction plates must not catch in the scores.
If the scores caused by the friction plates are deeper than 0.5 mm:
– Renew cylinder „C/D“.
Checking bearing bush in cylinder „C/D“ for wear
– Check running surfaces of bearing bush -arrow- inside cylin‐
der „C/D“ for wear.
• The running surfaces should not have any deep scoring and/
or blue discoloration.
If there are deep scores and/or blue discolouring:
– Renew cylinder „C/D“.
• Proceed as follows if the running surfaces have no blue dis‐
coloration and there is only slight scoring:
– Rub down running surface one or two times with abrasive pa‐
per and oil (grain size 600).
– Clean running surface thoroughly with clean cloth and check
running surface.
• The running surfaces should now be in as-new condition.
If scoring is still present after this step:
– Renew cylinder „C/D“.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
166 Rep. gr.39 - Final drive - front differential