Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Checking friction plates and outer plates for wear
Signs of overheating on the outer plates indicate that the friction
plates are worn. Assess the degree of wear as described below:
A - Heat discoloration spots at intervals of more than 20 mm: outer
plates and friction plates are OK; they can be used again.
B - Heat discoloration spots at intervals of less than 20 mm: outer
plates and friction plates are worn and require renewal.
C - If outer and/or inner parts of outer plates are discoloured blue
or brown: outer plates and friction plates are worn and require
renewal.
3.8 Clutch „E“
1 - Cylinder „E“ with annulus „I“
❑ Checking running surfa‐
ces for wear
⇒ page 177
4 - Piston „E“
❑ Check for wear
11 - Outer plate
❑ Checking for wear
⇒ page 177
12 - Friction plate
❑ Checking for wear
⇒ page 177
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
176 Rep. gr.39 - Final drive - front differential
To Next Page
Loading...
