Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
37 – Controls, housing
1 Securing gearbox to assembly stand
Procedure
• If the flange shaft (left-side) has been removed, the torque
converter must be secured using the support bridge -30 - 211
A- to prevent it from falling out.
– Attach support plate -VW 309- to hook and support tool
-3311- .
– Fit hook and support tool -3311- to attachment points on gear‐
box housing and secure in place.
– Use workshop hoist -VAS 6100- to attach gearbox to engine
and gearbox support -VAS 6095- .
Note
If the filled gearbox with oil pan is to be turned upside-down on
the engine and gearbox support, the gearbox housing and final
drive breathers must be sealed.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
18 Rep. gr.37 - Controls, housing
To Next Page
Loading...
