Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Place cover for front final drive together with differential on a
soft surface.
– Lever flange shaft (right-side) off differential -arrows- using
two levers.
– Drive oil seal for flange shaft out of cover for front final drive
using a drift.
– Cover splines on flange shaft (left-side) -arrow- with insulating
tape to prevent damage to oil seal between final drive and
gearbox housing when pulling out flange shaft. Take care to
cover the splines completely, without creasing or overlapping
the tape.
– Remove bolts -arrows- and detach baffle plate.
– Remove bolts -arrows- on mounting bracket for flange shaft
(left-side).
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
22 Rep. gr.37 - Controls, housing
To Next Page
Loading...
