Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Take body „II“ -item 1- off support -T10283- .
– Turn body „II“ to installation position.
• The ATF pump end must face upwards.
– Clip flange washer -1- onto body „II“.
• The flange on the flange washer faces towards body „II“.
– Renew rectangular section seals -2- on sun gear shaft of body
„II“ -item 1-.
– Lightly lubricate the rectangular section seals with vaseline
before fitting. Use vaseline only. Other types of lubricant will
cause the gearbox hydraulics to malfunction.
– Make sure that the rectangular section seals are fully seated
all round in the groove on the input shaft of body „II“ -item 1-,
otherwise they can be damaged when the ATF pump is fitted
later.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
34 Rep. gr.37 - Controls, housing
To Next Page
Loading...
