Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Renew seals on adapter -B-.
– Install adapter -B-.
Note
Item -A- can be disregarded.
Gearbox with 24 bolts on oil pan:
– Install mechatronic unit (24 bolts on oil pan)
⇒ „1.3 Removing and installing mechatronic unit - gearbox with
24 bolts on oil pan“, page 99 .
Gearbox with 13 bolts on oil pan:
– Renew O-rings for wiring harness connector.
– Fit wiring harness connector in gearbox housing.
• Lugs -1- and -2- on collar are horizontal, flat section -arrow- of
connector faces inside of gearbox.
– Fit retaining clip -arrow- for wiring harness connector.
– Install mechatronic unit (13 bolts on oil pan)
⇒ „1.4 Removing and installing mechatronic unit - gearbox with
13 bolts on oil pan“, page 102 .
Continued for all vehicles:
– Renew ATF strainer -arrow- and install ⇒ page 97 .
– Install ATF oil pan ⇒ page 93 .
– Turn gearbox on assembly stand.
• The ATF oil pan must face downwards.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
38 Rep. gr.37 - Controls, housing
To Next Page
Loading...
