Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Assembling
Caution
Check components of clutch „C“ for traces of wear and damage
⇒ „3.2 Clutch C “, page 165 .
– Renew O-rings -2- and -4- for piston „C“ -item 3-.
– Push piston „C“, -item 3- into cylinder „C/D“, -item 1- as far as
stop.
– Fit dished spring -5- and retaining ring -6-.
7 - Circlip
– Press dished spring down using workshop press with assem‐
bly jig -T10278- .
– Insert circlip -1-.
– Make sure that circlip is seated securely all round in groove
on cylinder „C/D“.
– Release workshop press.
– Insert corrugated spring -2- into cylinder „C/D“ -item 1-.
– Fit outer plates -3- and friction plates -4- alternately.
– Insert thick outer plate -5-.
– Insert circlip -6-.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
3. Dismantling and assembling body „I“ 51
To Next Page
Loading...
