Audi A6 - Dismantling and Assembling Piston;Cylinder D

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.5 Dismantling and assembling piston/cyl‐
inder „D“
Dismantling
– Press dished spring down using workshop press with assem‐
bly jig -T10277- .
– Remove split retaining ring -1-.
– Release workshop press.
– Detach dished spring -2- from cylinder „C/D“ -item 1-.
3 - Split retaining ring
– Press retaining plate -4- downwards by hand or using two
screwdrivers.
– Remove split retaining ring -5-.
– Detach retaining plate -4- and take O-rings -2- and -3- off re‐
taining plate and cylinder „C/D“ -item 1-.
Note
-Arrows- can be disregarded.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
3. Dismantling and assembling body „I“ 55