Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Carefully press retaining plate upwards with two screwdrivers
until it makes contact with retaining ring -arrows-.
– Fit dished spring -2- on cylinder „C/D“ -item 1-.
3 - Split retaining ring
– Press dished spring down using workshop press with assem‐
bly jig -T10277- .
– Insert split retaining ring -1-.
– Make sure that split retaining ring is seated securely all round
in groove on cylinder „C/D“.
– Release workshop press.
3.6 Adjusting clearance of clutch „D“
• Planetary drive „II“ and „III“ installed
Note
♦
The clearance of clutch „D“ can only be determined by meas‐
uring the dimensions of the gearbox housing because the
plates of clutch „D“ are inserted directly into the housing.
♦
The clearance is set by determining the required thickness of
the thick outer plate for clutch „D“.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
3. Dismantling and assembling body „I“ 57
To Next Page
Loading...
