Audi A6 - Page 62

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Overview
The instructions and dimensions in the following text refer to the
diagram shown here.
1 - Piston „D“
2 - Cylinder „C/D“
3 - Gearbox housing
4 - Clutch pack for clutch „D“ without thick outer plate
5 - Thick outer plate
Dimensions -a … g- are explained in the following text.
– Using digital depth gauge -VAS 6087- , measure depth in
gearbox housing from contact surface of ATF supply unit (as
reference point) to contact surface for plates of clutch „D“
-arrow-.
– Make a note of dimension -a-.
– Using digital depth gauge -VAS 6087- , measure depth in
gearbox housing from contact surface of ATF supply unit (as
reference point) to contact surface for cylinder „C/D“ -arrow-.
– Make a note of dimension -b-.
– Calculate installation height (dimension -c-) according to the
following formula:
c = a – b
– Make a note of dimension -c-.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
58 Rep. gr.37 - Controls, housing