Audi A6 - Page 67

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Take thrust washer -3- out of planet carrier „II“ and „III“
-item 2-.
Note
If necessary, the thrust washer can be made to come loose by
blowing compressed air under it and pulling it off with a wire hook.
– Take planet carrier „II“ and „III“ -item 2- out of annulus „III“
-item 1- with output shaft.
– Turn planet carrier „II“ and „III“ -item 1- upside down.
– Unclip axial needle bearing -2- from planet carrier „II“ and „III“
-item 1-.
– Remove thrust washer -2- from annulus „III“ -item 1- with out‐
put shaft.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
3. Dismantling and assembling body „I“ 63