Audi A6 - Page 68

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Turn annulus „III“ with output shaft upside down.
– Remove circlip -3-.
– Detach output shaft -2- from annulus „III“ -item 1-.
Assembling
– Engage splines of output shaft -2- in splines of annulus „III“
-item 1-.
– Install new circlip -3-.
– Turn annulus „III“ with output shaft upside down.
– Fit thrust washer -2- in annulus „III“ -item 1- with output shaft.
– Clip axial needle bearing -2- (bottom) onto planet carrier „II“
and „III“ -item 1-.
• The closed side of the axial needle bearing faces towards
planet carrier „II“ and „III“.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
64 Rep. gr.37 - Controls, housing