Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Detach retaining plate -4- with O-ring -3- from cylinder „A“
-item 1-.
– Detach dished spring -2-.
– Place cylinder „A“ -item 2- on ATF supply unit -1- as shown in
illustration.
WARNING
Wear safety goggles.
– Carefully press piston „A“ -item 3- out of cylinder „A“ using
compressed air.
Assembling
Caution
Check components of clutch „A“ for traces of wear and damage
⇒ „3.7 Clutch A “, page 175 .
– Renew O-rings -2- and -4- for piston „A“ -item 3-.
• Rib on O-ring -2- must be inserted in groove
– Push piston „A“, -item 3- into cylinder „A“, -item 1- as far as
stop.
– Fit dished spring -5-.
– Renew O-ring -6- for retaining plate -7-.
• Rib on O-ring -6- must be inserted in groove
– Insert retaining plate -7-, observing markings (see following
illustration „A37-10616“).
8 - Circlip
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
5. Dismantling and assembling body „II“ 79
To Next Page
Loading...
