Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.6 Dismantling and assembling clutch „E“
Dismantling
– Detach circlip -1- and remove clutch pack -2- from cylinder „E“.
– Press retaining plate down using workshop press with assem‐
bly jig -T10277- .
– Remove circlip -1-.
– Release workshop press.
– Detach retaining plate -5-.
– Take out retaining plate -4- with O-ring -3-.
– Detach dished spring -2- from cylinder „E“ -item 1-.
6 - Circlip
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
84 Rep. gr.37 - Controls, housing
To Next Page
Loading...
