Audi A7 2023 - Page 139

4K8012721BK
Driver assistance
EB\- The speed/distance control is active but the
vehicle is not ready to drive. No vehicles were de-
tected ahead. Your vehicle is stationary and will
not start driving automatically.
EBB Take over. The braking power is not suffi-
cient > page 139, Brake intervention request or
the safe start monitor is providing a warning
page 143.
[l- Lane guidance is active.
[BB- Take over steering. The system limits have
been reached > page 139, Steering intervention
requests.
Bl- Lane guidance is switched on but it is not ac-
tive > page 139, Lane guidance limitations.
BV B- Take over steering. No steering detect-
ed or a system limit has been reached
page 139, Steering intervention requests.
Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras > page 119.
Using adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
E
|
F
3
Fig. 93 Operating lever: changing the speed
Switching on
» To switch on the adaptive cruise assist, pull the
lever up to position @ until it engages.
Storing the speed and activating regulation
Ifyou have switched the system on, you can set.
the current speed as the “regulated speed” and
activate regulation:
> Press the button @). The set speed is indi-
cated with a marking in the speedometer @)
© page 136, fig. 90 and shown in the instru-
ment cluster > /\.
» To save the speed while the vehicle is station-
ary, also hold the brake pedal down.
You can set any speed between 15 mph
(20 km/h) and the maximum possible speed
range @) page 136, fig. 90.
Pausing cruise control
The control can be stopped at any time:
» While driving or when the vehicle is stationary:
Press the lever away from you in the direction
of the arrow. Or
» While driving: Press the brake pedal.
The [Ef indicator light turns off.
Resuming regulation
The previously set speed can be resumed at any
time after a pause.
» To resume cruise control while driving, pull the
lever toward you in the direction of the arrow.
» To resume cruise control when stationary, pull
the lever toward you in the direction of the ar-
row while pressing the brake pedal.
Changing the speed
» To increase or decrease the set speed in smaller
increments, briefly tap the lever toward @) or
© to the first level.
» To increase or decrease the set speed in larger
increments, briefly tap the lever toward @) or
© to the second level.
» To increase or decrease the set speed continu-
ously, hold the lever toward @) or ©) until the
marking in the speedometer @) > page 136,
fig. 90 has reached the desired speed.
137