Audi A7 2023 - Page 289

4K8012721BK
Emergency assistance
— Please note that the tire mobility kit cannot
be used in all situations, and that it may on-
ly be used temporarily.
— The tire sealant must not come in contact.
with skin, eyes, or clothing.
- If tire sealant comes into contact with your
eyes or your skin, thoroughly rinse the af-
fected area immediately with clean water.
Do not inhale the fumes.
— If you swallow any of the tire sealant, thor-
oughly rinse your mouth immediately and
drink a lot of water. Do not induce vomiting.
Seek medical attention immediately.
— Change your clothing immediately if it
comes into contact with tire sealant.
—If an allergic reaction occurs, seek medical
attention immediately.
—Keep the tire sealant away from children.
— In vehicles with a tire pressure monitoring
system”, using tire sealant can result in an
incorrect display or a system malfunction.
Drive carefully to the nearest authorized
Audi dealer or authorized Audi Service Facili-
ty.
OH Batteries and electrical/electronic d
must be disposed of in an environmentally
safe manner.
Ss
sealant leaks, allow it to dry in place. You
can then peel it off like a sticker.
— Note the expiration date on the sealant bot-
tle. Replace the tire sealant at an author-
ized Audi dealer or authorized Audi Service
Facility.
— Radio reception can be interrupted when
‘operating the compressor.
— Follow the legal regulations that are appli-
cable in the country where you are operat
ing the vehicle.
1) The compressor may look different. However, the way itis
operated is generally the same.
Repairing tires
Applies to: vehicles with tie mobility kit
Requirement: the tire mobility kit must be laid
out and ready for use ® page 286.
Setting up the tire mobility kit
» Open the cover @) on the compressor!)
© fig. 162.
» Remove the connector @) and pressure hose ©)
from the housing.
» Connect the compressor pressure hose () to
the flange © on the tire sealant bottle @.
> Insert the sealant bottle with the flange at the
bottom into the opening @) on the compressor.
» Remove the valve cap from the faulty tire.
> Connect the filler hose © to the valve @
fig. 163.
» Connect the plug @ © fig. 162 to an outlet in
the vehicle.
>
Switch
the
ignition
on.
287