Audi A8 1994 - Body - Front; Wing Mounting Flange - Renewal; Procedure

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
50 – Body - front
AP: 50 52 55 00
1 Wing mounting flange - Renewal
1.1 Procedure
1.1.1 Cutting locations
– Wing mounting flange to cast joint, welded seam.
– Wing mounting flange to support, welded seam.
– Wing mounting flange to plenum chamber, welded seam.
– Detach part.
Note:
♦ Partial replacement is possible with the separating cuts illustrated.
♦ Insert sleeve and weld in, SG continuous seam.
Caution:
Take care not to damage cast joints and extruded sections on
separation.
1.1.2 Replacement part
♦ Wing mounting strip
Audi A8 1994 ➤
Body repairs - Edition 10.1998
1. Wing mounting flange - Renewal 29