Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
AP: 53 55 55 00
5 Side panel - Renewal
5.1 Procedure
5.1.1 Cutting locations
Note:
♦
Side panel is foam-filled in area of lower part and D-pillar.
♦
Partial renewal at the front or rear is possible with the given separating cut -b-.
♦
Max. cutting depth 3 mm.
♦
Take care not to damage inner reinforcement when cutting.
♦
Place an additional thickness of the same material behind the joint or overlap in the hatched area.
Audi A8 1994 ➤
Body repairs - Edition 10.1998
78 Rep. Gr.53 - Body - rear
To Next Page
Loading...
