Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Separating cut, D-pillar 60 mm below original joint.
– Separating cut at bottom, 30 mm above sill panel, inside re‐
cess for sill panel trim.
– Roughly cut out rear area with separating cut -a- and detach.
– Use body saw to separate filler neck compartment retaining
bracket.
– Grind through outer edge of wheel housing.
Audi A8 1994 ➤
Body repairs - Edition 10.1998
5. Side panel - Renewal 79
To Next Page
Loading...
