Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Language version Code
Spanish 5
Portuguese 6
Chinese 8
- Use slide bar to change adaption value =>"A - Changing adaption value with slide bar", Page 31 .
Or
- Change adaption value by means of direct entry => "B - Changing adaption value by means of direct entry",
Page 32 .
- Enter 5-digit adaption value. Use "0" to fill up blanks.
Example:
Code: 1 (German)
Keypad entry: 00001
-> Readout on VAS 5051 following adaption:
Example:
1 - Channel 4
Value 1 saved
- Terminate function "10 - Adaption" by touching ◂ key.
Adaption channel 09 - Entering mileage after replacing dash panel insert
This function can be used to enter mileage count on dash panel insert replacement.
Notes:
◆ Adaption is only possible for dash panel inserts with a mileage of up to max. 100 km.
◆ Adaption can only be performed once for a given dash panel insert.
◆ It is only possible to enter a higher adaption value (greater than 100 km).
◆ Up to model year 2001: Confirmed incorrect entries cannot be corrected. Dash panel insert must then be
replaced.
◆ As of model year 2002: Incorrect entries can be corrected until a distance of 5 km has been covered once
following initial change.
◆ Adaption is implemented in miles in countries where distances are measured in miles.
Audi A8 1994 ➤
Electrical system Self-diagnosis 02.99 ➤ - Edition 05.2002
38 01 - Self-diagnosis
To Next Page
Loading...
