Audi A8 1994 - Leaking or Damaged Components Except A;C Compressor, Accumulator or Receiver - Circuit Contains Refrigerant; Compressor, Replacing Without Flushing Refrigerant Circuit

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.2 Leaking or Damaged Components Ex‐
cept A/C Compressor, Accumulator or
Receiver - Circuit Contains Refrigerant
Refrigerant circuit still contains refrigerant (for example, with mi‐
nor leak)
– Discharge refrigerant circuit
– Remove malfunctioning component, flush with compressed
air, collect escaping refrigerant oil.
– The new component is to be filled with the amount of refriger‐
ant oil flushed out (positive 20 cm
3
for evaporator, positive 10
cm
3
for condenser, refrigerant pipes and refrigerant hoses) as
fresh refrigerant oil fill.
Note
Workshop-specific instructions, refer to Audi ServiceNet, HSO
Environment.
– Replace restrictor.
– Assemble, evacuate and charge refrigerant circuit.
5.3 Compressor, Replacing Without Flush‐
ing Refrigerant Circuit
Note
Cleaning refrigerant circuit means flushing it with refrigerant
R134a, refer to
⇒ “1.4.13 Refrigerant Circuit Flushing With Refrigerant R134a“,
page 32 or blowing through with compressed air and nitrogen,
refer to
⇒ “1.4.12 Refrigerant Circuit Flushing With Compressed Air and
Nitrogen “, page 29 ).
For example, in the event of external damage following an acci‐
dent
– Discharge refrigerant circuit
– Remove A/C compressor.
– Remove oil drain plug from A/C compressor.
Note
Different versions of the oil drain plug and its seal (it can be either
an O-ring or a gasket; always replace). Refer to
⇒ “5.1 Leaking or Damaged Components Except A/C Compres‐
sor, Accumulator or Receiver - Circuit Empty of Refrigerant“, page
191 and to the Electronic Parts Catalog (ETKA).
– To accelerate drainage of refrigerant oil, rotate compressor,
for example, by way of clutch plate of A/C clutch for example.
– Drain the old refrigerant oil from the A/C compressor* (for dis‐
posing, refer to Audi-ServiceNet, HSO Environment).
– Remove oil drain plug from replacement A/C compressor,
pour out refrigerant oil and only add a quantity of fresh refrig‐
Audi 100 1991 ➤ , Audi 80 1992 ➤ , Audi A1 2011 ➤ , Audi A2 2001 ➤ , A ...
Refrigerant R134a Servicing - Edition 01.2011
5. Removal and Installation 193