Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
♦
The critical values listed are always given for one diesel par‐
ticulate filter.
♦
For vehicles with two exhaust pipes, the ash deposit volume
must be read out for both diesel particulate filters.
3.2 Event memory: reading out and erasing
Procedure:
– Connect vehicle diagnostic tester ⇒ page 14 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– Select “Working with Guided Fault Finding” by entering v and
press Apply
.
The control unit is then identified, and the event memory is inter‐
rogated. Observe notes and test conditions.
– Switch to “Control units” tab and call up “Event memory list”
for an overview of all entries stored in event memory.
– Correct relevant faults and erase event memory.
Note
The event memory is erased automatically if the Guided Fault
Finding is closed correctly.
3.3 Navigation system (MMI high): releasing
eject button
Procedure:
– Connect vehicle diagnostic tester ⇒ page 14 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab and select following program:
♦ 5F - Lock / release eject button
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
3.4 Navigation system (MMI basic): releas‐
ing eject button and running CD for lan‐
guages
Step 1 - releasing eject button:
– Connect vehicle diagnostic tester ⇒ page 14 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
Audi A8 2003 ➤
Maintenance - Edition 06.2014
20 3. Maintenance
To Next Page
Loading...
