Audi A8 2003 - Service Interval Display: Resetting Service; Transport Mode: Deactivating

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab and select following program:
♦ 5F - Lock / release eject button
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
Step 2 - installing language:
– Activate MMI.
– Take “Navigation cues and speech dialogue system” CD out
of glove box and insert it into CD/DVD drive.
– Press function selector button SETUP .
– Select following menu under control button »Settings«:
♦ Language
– Use MMI rotary pushbutton to select desired language.
– Put CD back when finished.
3.5 Service interval display: resetting serv‐
ice
Procedure:
– Connect vehicle diagnostic tester ⇒ page 14 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab.
– Select service setting to be reset (e.g. “17 — Inspection”).
– Start program by selecting Carry out check .
– Continue to follow instructions on screen.
Note
Please refer to the relevant Maintenance table for information on
which service channel to reset and what data to enter.
3.6 Transport mode: deactivating
Procedure:
– Connect vehicle diagnostic tester ⇒ page 14 .
– Select Diagnosis mode and begin diagnosis.
– Perform vehicle identification.
– De-select “Working with Guided Fault Finding” by removing
v and press Apply .
– Switch to “Special functions” tab and select following program:
♦ 19 - Activating / deactivating transport mode
– Start program by selecting Carry out check .
Audi A8 2003 ➤
Maintenance - Edition 06.2014
3. Maintenance 21