Audi A8 2003 - Rear Lid Hinges: Lubricating; Bonnet Arrester Hook: Lubricating

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Apply lubricating paste - G 060 751 A2- to side guide rail of
sliding headliner -arrow- using paintbrush.
– Repeat cleaning and lubricating procedure on opposite side of
vehicle.
– Remove surplus lubricant with cloth.
– Open and close roof system completely and check again for
surplus lubricant.
3.25 Rear lid hinges: lubricating
Special tools and workshop equipment required
♦ Universal spray oil - G 000 115 A2-
Requirements:
• The vehicle must be at least at room temperature.
Procedure:
– If fitted, remove cover for rear lid hinges.
– First clean all lubricating points with a lint-free cloth.
– Lubricate rear lid hinges at hinge joints shown -arrows- with
universal spray oil - G 000 115 A2- .
– Remove surplus lubricant with cloth.
– Repeat procedure on opposite side of vehicle.
– If originally fitted, re-install cover for rear lid hinges.
3.26 Bonnet arrester hook: lubricating
Special tools and workshop equipment required
♦ Universal spray oil - G 000 115 A2-
Requirements:
• The vehicle must be at least at room temperature.
Procedure:
– First clean all lubricating points with a lint-free cloth.
Audi A8 2003 ➤
Maintenance - Edition 06.2014
44 3. Maintenance