Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fitting location of temperature sender for engine temperature
regulation -G694-
♦ -Item 1- below intake manifold (bottom section) on cylinder
bank 1 (right-side)
Removing and installing ⇒ Rep. gr. 19
Fitting locations below intake manifold (bottom section) on cylin‐
der bank 2 (left-side)
1 - Injector, cylinder 6 -N84-
2 - Injector, cylinder 5 -N83-
3 - Injector, cylinder 4 -N33-
4 - Fuel pressure sender -G247-
5 - Knock sensor 2 -G66-
Fitting location of throttle valve module -J338-
♦ At rear of supercharger
Fitting location of regulating flap control unit -J808-
3 - Regulating flap control unit -J808-
♦ At rear of supercharger
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
12 Rep. gr.24 - Mixture preparation - injection
To Next Page
Loading...
