Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.2 Removing and installing engine control
unit -J623-
Special tools and workshop equipment required
♦ Removal lever -80 - 200-
Removing
– If engine control unit is renewed, select test sequence/function
Replace engine control unit in Guided Functions
mode ⇒ vehicle diagnostic tester .
– Switch off ignition.
– Remove wiper arms ⇒ Electrical system; Rep. gr. 92 .
– Detach seal -1- from plenum chamber cover.
Caution
Risk of damage to plenum chamber cover.
♦ Apply a small amount of soap solution to transition be‐
tween windscreen and plenum chamber cover.
– Remove plenum chamber cover -2- ⇒ Rep. gr. 50 .
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
48 Rep. gr.24 - Mixture preparation - injection
To Next Page
Loading...
