Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolts -arrows- from cylinder bank 2 and unplug elec‐
trical connectors at ignition coils.
– Move electrical wiring harness down slightly.
Note
Disregard -items 1, 2, 3-.
– Remove ignition coils using puller -T40039- .
Installing
Tightening torques
• ⇒ „2.3 Air cleaner - exploded view“, page 17 .
• ⇒ „2.2 Ignition system - exploded view“, page 52 .
Install in reverse order.
2.4 Removing and installing knock sensors
-G61- / -G66-
Removing
– Remove supercharger ⇒ Rep. gr. 21 .
– Remove corresponding intake manifold (bottom section)
⇒ page 27 .
– Take electrical connector -3- (cylinder bank 1) out of bracket.
– Remove electrical connector -2- for knock sensor 1 -G61- from
bracket and unplug connector.
Note
Disregard -item 1-.
Audi A8 2010 ➤
Simos direct petrol injection and ignition system (6-cyl. 3.0 ltr. TFSI 4-valve) - Edition 12.2011
54 Rep. gr.28 - Ignition system
To Next Page
Loading...
