Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Make separating cuts at C and D-pillar according to extent of
damage.
– Make separating cuts in side member according to extent of
damage. Take care not to damage internal reinforcement.
– Grind through outer edge at wheel arch using compact angle
grinder - VAS 5167- .
– Separate original joint with rechargeable riveter -VAS 5279A- .
Audi A8 2003 ➤
Body Repairs - Edition 05.2011
4. Side panel - Renewal 107
To Next Page
Loading...
