Audi Q3 2024 - Page 121

83A0127218K
Driving information
Limitations
The traffic sign recognition is subject to certain
system limitations and may be unavailable or on-
ly partially available in the following situations:
= When visibility is poor, such as in snow, rain,
fog, or heavy spray
—When there is glare, for example from oncom-
ing traffic or the sun
~At high speeds
~ If the camera's visual field @ page 115 is cov-
ered, for example by dirt or stickers. For infor-
mation on cleaning, see > page 247.
~ If the traffic signs are completely or partially
covered, for example by trees, snow, dirt, or
other vehicles
~ If traffic signs do not conform to the standard
format
~ If traffic signs are damaged or bent
~ If traffic signs are displayed on sign holders
with electronic signs
~ If the traffic signs or the roadways have
changed, and the navigation data is no longer
up-to-date
— Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 114 to > page 117.
— Under some circumstances, traffic sign rec-
cognition may not detect traffic signs correct-
ly or detect them at all. Asa result, the sys-
tem may not display the correct speed limit
or any speed limit.
= Traffic sign recognition only informs and
warns about speed limits. Depending on the.
vehicle equipment, additional driver assis-
tance systems can adjust the vehicle speed.
—The display in the instrument cluster is
based on the units of measurement used for
speed in the country where the vehicle is be-
ing operated. As a result, the display 50 in
the instrument cluster can mean either
km/h or mph, depending on the country.
‘Applies to: vehicles with camera-based traffic sign recogni
tion
Accessing traffic sign recognition
» Select in the instrument cluster: vehicle func-
tions tab > Traffic signs.
Setting a traffic sign based speed warning
You can adjust the speed warning threshold to
your preferences in the Driver assistance menu
© page 117. The settings depend on the vehicle
equipment.
Possible settings:
Speed warning - you can select a warning thresh-
old. If you exceed this, then the current detected
speed limit will be shown in the display with an
exclamation point for the duration that it is ex-
ceeded and it will blink for a short time.
Messages
‘Applies to: vehicles with camera-based traffic sign recogni-
tion
The following messages may appear depending
on the vehicle equipment:
Traffic sign recogni
view limited due to environm. conditions
The camera’s visual field is covered. Clean the
windshield.
Traffic sign recogni
See owner's manual
n: currently limited.
This message appears if navigation system data
is not available, for example on newly-construct-
ed roads. The speed limit display will be tempo-
rarily limited, which increases the risk of an incor-
rect display. If this message continues to appear,
drive immediately to an authorized Audi dealer or
authorized Audi Service Facility to have the mal-
function repaired.
No traffic sign information available
Depending on the area, there is no valid naviga-
tion data and no speed limits were detected. This
may also appear if there is a recommended
speed, but no speed limit (for example when
driving on and off the expressway).
119
OwnersManuals2.com