Audi Q3 2024 - Page 132

Driver assistance
do or may not be suitable for the weather
and road conditions. If necessary, apply the
brakes and reduce the selected speed to be
maintained in the Adjustment to curves
along route setting to reduce the risk of an
accident.
Om
— Predictive control can exceed or drop below
the maximum permitted speed. The driver
is always responsible for adhering to the
permitted speed limits.
~The traffic signs on the road always take pri-
ority over the display. The driver is always
responsible for adhering to the regulations
applicable in the country where the vehicle
is being operated.
— The system only detects traffic signs that
specify a speed limit.
— The display in the instrument cluster is
based on the units of measurement used for
speed in the country where the vehicle is be-
ing operated. As a result, a display of SO in
the instrument cluster can mean either mph
or km/h, depending on the country.
— If a speed limit is detected, the marking @)
© page 125 of the set speed limit will be ad-
justed even if the adaptive cruise assist is
not actively regulating.
— Control by the system depends on which
adaptive cruise assist driving program is set
or on the selected Audi drive select* mode.
— After switching on the ignition and first
driving onto a freeway or similar road with-
out a speed limit, the system will regulate
the speed to 80 mph (130 km/h)”. Then
the system adjusts to the last speed set by
the driver.
— There is no adaptation to speed limits when
driving through highway interchanges and
when driving on or off the expressway.
—The system can fail to provide control or the
control may be faulty if the values from the
camera-based traffic sign recognition* are
) Incertain countries.
130
incorrect or the navigation system* map da-
ta is outdated.
— Except for the road network, which is re-
corded in the navigation system's map infor-
mation, certain functions may not be availa-
ble.
— When route guidance is switched on, the
system adapts to the route provided by the
navigation system. Driving without route
guidance or leaving a route can result in
faulty control.
Setting the distance
Applies to: vehicles with adaptive cruise assist
4M.234
Fig. 105 Operating lever: setting the distance
When approaching a vehicle driving ahead, the
adaptive cruise assist brakes to the set speed and
then maintains the set distance. If the vehicle
driving ahead accelerates, then the adaptive
cruise assist will also accelerate up to the speed
that you have set.
» Tap the rocker switch to display the distance
that is currently set.
» To increase or decrease the distance in incre-
ments, tap the switch again toward @ or ©.
The newly-set distance will be shown briefly, for
example with the [Ej indicator light.
If you adjust the speed, you must also change the
time gap to the vehicle driving ahead. The higher
the speed, the greater the distance that is need-
ed. The following distances can be set:
OwnersManuals2.com