Audi Q3 2024 - Distance Warning

83A012721BK
Driver assistance
elect Applies to: vehicles with Audi dri
Vehicle handling will be adjusted based on the
selected Audi drive select mode > page 105.
Store last distance - The last distance that was
set will be stored after the ignition is switched
off. If the distance is not stored, distance [El
(time distance of approximately 1.8 seconds) is
automatically preset every time the ignition is
switched on
Predictive control > Set speed limit - adaptation
to speed limits can be switched On or Off. Regu-
lation With tolerance can also be selected, if de-
sired. In this scenario, you may fall below or ex-
ceed the set speed in favor of increased efficien-
y.
Predictive control > Adjustment to curves along
route - regulation based on the road ahead can
be switched Off or set from Slow to Fast based
on your preference. The setting influences vehicle
handling with predictive control, for example the
speed for driving through curves.
Messages
Applies to: vehicles with adaptive cruise assist
1 [or Bilis displayed when there is a malfunc-
tion, the adaptive cruise assist functions may be
unavailable or limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors © page 116 and try to turn the system on
again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Facili-
ty immediately to have the malfunction correct-
This message appears if the vehicle rolls back
when starting on a slight incline, even though the
systems are active. Press the brake pedal to pre-
vent the vehicle from rolling or starting to move.
The message will also appear, for example if the
steering power from the system is not sufficient
and adaptive cruise assist is switched off.
Distance warning
‘Applies to: vehicles with adaptive cruise assist
Fig. 108 Instrument cluster: display of the current dis-
tance
‘Applies to: vehicles with adaptive cruise assist:
Fig. 109 Instrument cluster: distance warning
General information
At speeds above approximately 40 mph (65
km/h), this function measures the distance to
the vehicle ahead as time. If the distance falls be-
low the warning threshold and remains there,
the system will warn you of the hazard with the
BB indicator tight.
Image in the Driver assistance display
Applies to: vehicl h adaptive cruise assist
The display only appears if the Driver assistance
display is selected on the on-board computer
© page 17 and the adaptive cruise assist is not
actively controlling the vehicle.
@ Detected vehicle driving ahead
@® Use the markings to help you estimate the
distance to an obstacle. Each marking repre-
sents approximately one second. >
133
OwnersManuals2.com