Audi Q3 2024 - Lane Departure Warning

Driver assistance
© Set warning threshold. Depending on the set-
tings, the display will be colored in from the
bottom to the top.
@ The actual distance is smaller than the set
distance and you will be informed about the
danger.
Adjusting the distance warning
— You can turn the distance warning on or off in
the Driver assistance menu, or adjust it to your
preferences > page 117. The settings depend
on the vehicle equipment.
Possible settings:
— Warning threshold
Messages
1 BB or Bis displayed when there is a malfunc-
tion, the distance warning functions may be un-
available or may be limited.
A message that indicates the cause and possible
solution may appear with some displays. The
weather conditions may be too poor or a sensor
may be covered. Clean the area in front of the
sensors page 116 and try to turn the system on
again later.
If the malfunction remains, drive to an author-
ized Audi dealer or authorized Audi Service Facili-
ty immediately to have the malfunction correct-
ed.
ZA WARNING
Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 114 to > page 117.
@ Tips
~The driver is always responsible for adhering
to the regulations applicable in the country
where the vehicle is being operated.
You may fall below the warning threshold
briefly when passing or when quickly ap-
proaching a vehicle driving ahead. There is
no warning in this scenario. A warning is giv-
en only if you fall below the warning thresh-
old for an extended period of time.
134
Lane departure warning
ning
The lane departure warning can detect lane
marker lines within the limits of the system. If
you are approaching a detected lane marker and
it appears likely that you will leave the lane, the
system can warn you with corrective steering and
a steering wheel vibration, if necessary.
The system functions in the speed range of ap-
proximately 40 mph - 155 mph (65 km/h -
250 km/h).
Z\ WARNING
Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras © page 114 to > page 117.
marou|
Fig. 110 Turn signal lever: button for lane departure warn-
ing and lane guidance for adaptive cruise assist*
Fig. 111 Instrument cluster: driver assistance display
Switching the lane departure warning on and
off
» To switch the system on or off, press the but-
ton @ on the turn signal lever. The [SN or HN >
OwnersManuals2.com