Audi Q3 2024 - Telephone; Infotainment System; Introduction; Setup

83A012721BK
Telephone
Telephone
Introduction
Applies to: vehicles with telephone
You can operate various telephone functions easi-
ly through the MMI in your vehicle.
Depending on the country and the vehicle equip-
ment, the following options may be available:
— Connecting a cell phone with Bluetooth
—Using two telephones
— Using the Audi phone box
—Medical experts warn that mobile devices
can interfere with the function of pacemak-
ers. Always maintain a minimum distance of
about 7.9 inches (20 cm) between the mo-
bile device antennas and the pacemaker.
—Do not carry the mobile device in a pocket
directly over the pacemaker when the
phone is switched on.
— Switch the mobile device off immediately
if you suspect it may be interfering with
the pacemaker.
—Do not use the voice recognition system*
© page 27 in emergencies because your
voice may change in stressful situations. The
system may take longer to dial the number
or may not be able to dial it at all. Dial the
emergency number manually.
— Switch your mobile device off in areas where
there is a risk of an explosion. These loca-
tions are not always clearly marked. T!
may include gas stations, fuel and chemical
storage facilities or transport vehicles, or lo-
cations where fuel vapors (such as propane
or gasoline vapor in vehicles or buildings),
chemicals or large quantities of dust parti-
cles (such as flour, sawdust or metal) may
be present in the air. This also applies to all
other locations where you would normally
switch your engine/motor off.
~The demands of traffic require full attention
of all road users. Always read the chapter
© page 21, Traffic safety information.
Read the information about Audi connect, and
be sure to note the connectivity costs section
page 166.
~The Bluetooth connection range is limited
to inside the vehicle.
—A selection of supported Bluetooth devices
can be found in the database for tested mo-
bile devices at www.audi.com/bluetooth.
Setup
Connecting a mobile phone via Bluetooth
Applies to: vehicles with telephone
Requirement: the vehicle must be stationary and
the ignition must be switched on. The Bluetooth
settings must be open on your mobile device dur-
ing the connection setup. The mobile device to be
connected must not be actively connected to any
other Bluetooth device. The MMI must only be
connected to one mobile device.
» Enable the Bluetooth function and visibility on
the MMI ® page 206 and the mobile phone.
» Applies to: MMI: Select on the home screen:
TELEPHONE.
» Follow the system instructions. The available
Bluetooth devices will be displayed after sever-
al seconds.
» Press on the desired mobile device in the list of
displayed Bluetooth devices.
> To update the list, press Q.
APIN for a secure Bluetooth connection will be
generated.
» Confirm the PIN on your mobile device.
» Follow the system instructions.
» Pay attention to any other system prompts on
the MMI and on your cell phone.
After connecting successfully
The cell phone contacts are automatically loaded
in the MMI. This process can take several mi-
nutes, depending on the number of contacts.
Depending on your cell phone and the connection
type, you can use the following functions: >
155
OwnersManuals2.com