Audi Q3 2024 - Odometer; Outside Temperature Display; Engine Oil Temperature Indicator; Vehicle Functions

83A012721BK
Instrument cluster
Odometer
The trip odometer and odometer are displayed in
the status bar ©) page 14.
The trip odometer shows the distance driven
since it was last reset. It can be used to measure
short distances. The odometer shows the total
distance that the vehicle has been driven.
Resetting the trip odometer
» Select on the instrument cluster: vehicle func-
tions tab > I button > Reset mi.
Distances are displayed in mi (miles) or km
(kilometers).
Outside temperature
display
The outside temperature is displayed in the sta-
tus bar ©) Spage 14.
If your vehicle is stationary or if you are driving at
very low speeds, the temperature displayed in
the instrument cluster may be slightly higher
than the actual temperature outside due to heat
radiating from the motor.
At temperatures below 41 °F (+5 °C), a snowflake
symbol appears in front of the temperature dis-
play >A.
Do not assume the roads are free of ice based
on the outside temperature display. Be aware
that there may be ice on roads even when the
outside temperature is around 41 °F (+5 °C)
and that ice can increase the risk of accidents.
Engine oil temperature
indicator
Applies to: vehicles with engine oil temperature indicator
Depending on the vehicle equipment, the engine
oil temperature sz may be indicated by a bar in
the instrument cluster.
» Open the vehicle functions tab and switch to
the enhanced view page 15.
When engine oil temperatures are low, the dis-
play --- °F (--- °C) appears in the instrument clus-
ter. The engine has reached its operating temper-
ature when the engine oil temperature is be-
tween 176 °F (80 °C) and 248 °F (120 °C) under
normal driving conditions. The engine oil temper-
ature may be higher if there is heavy engine load
and high temperatures outside. This is not a
cause for concern as long as the ij or Elindica-
tor lights do not turn on.
Vehicle functions
Overview
The trip computer is displayed in the first tab of
the driver information system. Additional vehicle
functions can be accessed depending on the vehi-
cle equipment.
» Press the [) button on the multifunction steer-
ing wheel.
—Trip computer © page 17
— Reduced display @ page 16
— Reset trip odometer @ page 17
On-board computer
Changing the display
» Turn the left thumbwheel on the multifunction
steering wheel ) © page 15, fig. 6 until the
desired display is shown.
Resetting values to zero
Requirement: the Consumption, Short-term
memory, or Long-term memory display must be
selected.
> To reset the values in one of the memories to
zero, press and hold the left thumbwheel on
the multifunction steering wheel for one sec-
ond, or
> Select on the instrument cluster: vehicle func-
tions tab > J button > Reset mi.
17
OwnersManuals2.com