Audi Q3 2024 - Page 257

83A012721BK
Emergency assistance
Anti-theft wheel bolts
Applies to: vehicles with anti-theft wheel bolts
;
>
a
Fig. 162 Anti-theft wheel bolt with cap and adapter
B4H.0470
i
You need a special adapter in the vehicle tool kit
to remove the anti-theft wheel bolts.
» Remove the cap @).
» Slide the adapter @) all the way onto the anti-
theft wheel bolt @.
» Slide the wheel wrench* from the vehicle tool
kit all the way onto the adapter @.
> Loosen the wheel bolt > page 255.
@ Ts
Note the code number for the wheel bolt
adapter and store it in a safe place separate
from the vehicle. If you need a replacement
adapter, contact an authorized Audi dealer or
authorized Audi Service Facility and give them
the code number.
Loosening the wheel bolts
Fig. 163 Wheel: loosening the wheel bolts
) You need the matching adapter in order to loosen and
tighten anti-theft wheel bolts* page 255.
» Slide the wheel wrench* from the vehicle tool
kit all the way onto the wheel bolt”)
» Turn the wheel bolt approximately one turn to
the left. To achieve the required torque, hold
the end of the wheel wrench*. If the wheel bolt
will not loosen, press carefully on the wheel
wrench* with your foot. Hold onto the vehicle
securely while doing this and make sure your
footing is stable.
_ WARNING
To reduce the risk of an accident, only loosen
the wheel bolts gently one turn before raising
the vehicle with the vehicle jack".
Raising the vehicle
Applies to: vehicles with vehicle jack
Fig. 165 Sill: positioning the vehicle jack
> Place the vehicle jack from the vehicle tool kit
ona firm surface. Use a flat, stable support if
necessary. Ona slippery surface such as tile,
you should use a non-slip pad such as a rubber
mat > A\. >
255
OwnersManuals2.com