Audi Q3 2024 - Page 51

83A0127218K
Opening and closing
first three spots to the systems that you would
also like to use when driving in reverse.
» To display the -@ button for the garage door
opener, press the =] button in the status bar
© page 24.
> If you are programming the garage door opener
for the first time, press the @ button on the
center display. Follow the instructions in the
MMI. Or
> If you would like to program other systems, se-
lect on the home screen: VEHICLE > Settings &
Service > Garage opener. Select the desired
button: ©. Follow the instructions in the MMI.
> If you would like to reprogram systems that are
already programmed, select on the home
screen: VEHICLE > Settings & Service > Garage
opener. Press the 4 button and select 7 for
the system to be reprogrammed. Select: Pro-
gram. Follow the instructions in the MMI.
With some systems, the garage door opener will
be
immediately available after programming.
With other systems, the garage door opener
must also be synchronized.
Synchronizing”
Requirement: the hand transmitter must already
be programmed and the vehicle must be within
range of the system (such as the garage door).
If the system synchronization is performed di-
rectly after the programming procedure, follow
the instructions on the MMI.
If you would like to sync at a later time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the button for the system that you would
like to synchronize.
» Follow the instructions in the MMI.
Location pairing
Applies to: vehicles with location pairing
For easier operation, you can program your sys-
tem’s location.
1 Only applies to rolling code systems
Requirements: the respective hand transmitter
must be programmed page 48 and the vehicle
must be located in front of the system.
» Ifyou have programmed your system, follow
the instructions in the MMI. Or
If you would like to set up location pairing at an-
other time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the Z button.
> Press the 7 button for the system your vehicle
is facing.
» Select: Location pairing.
» Follow the instructions in the MMI.
Only a maximum of three systems can be dis-
played in the notification center > page 24. If you
would like to have all systems displayed, press
oo
88.
Renaming programmed systems
You can rename the programmed systems ac-
cording to your preferences (names may have a
maximum of 10 characters).
» Ifyou have programmed your system, follow
the instructions in the MMI. Or
If you would like to change the name at another
time:
> Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
> Press the Z button.
» Press the 7 button for the system that you
would like to rename.
» Select: Rename. If necessary, delete the preset
name, such as Garage door opener 1.
> Follow the instructions in the MMI.
Deleting programmed systems
The programmed systems can be deleted individ-
ually or all at once.
> Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the Z button.
ao
OwnersManuals2.com