Audi Q3 2024 - Page 55

83A012721BK
Lights and vision
headlights are not switched on, the high beam
assistant will remain activated.
~ Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 114 to >page 117.
High beam assistant is only intended to as-
sist the driver. The driver is always responsi-
ble for controlling the high beam headlights
and adjusting them based on the lighting
and visibility conditions.
— High beams can cause glare for other per-
sons, which increases the risk of an accident.
For this reason, only use the high beams or
the headlight flasher when they will not cre-
ate glare for other drivers.
Adhere to any local applicable regulations
when using the lighting equipment, for exam-
ple in regard to reducing glare for other road
users. The driver is always responsible for ad-
hering to the regulations applicable in the
country where the vehicle is being operated.
Adjusting the exterior lighting
The following settings depend on the vehicle
equipment.
» Applies to: MMI: Select on the home screen:
VEHICLE > Light & Visibility > Exterior light
ing.
Automatic headlights
You can adjust the following settings in the Auto-
matic
headlights menu:
Activation time - You can adjust if the headlights
switch on Early, Medium, or Late based on the
sensitivity of the light sensor.
High beam assistant - You can switch the high
beam assistant on and off.
Entry/exit lighting
The Entry/exit lighting illuminates the area
around the vehicle when the vehicle is unlocked
or when the driver's door is opened while the ig-
nition is off. The entry/exit lighting works when it
is dark and when the AUTO light function is
switched on. The daytime running lights switch
on automatically each time the vehicle is un-
locked, regardless of how bright it is outside the
vehicle.
Daytime running lights
USA models: The daytime running lights can be
switched on and off.
Canada models: This function cannot be switched
off. They activate automatically each time the ig-
nition is switched on.
ergency flashe
=
Fig. 40 Center console: emergency flashers
The emergency flashers help to make other road
users aware of your vehicle in dangerous situa-
tions.
» Press the A @ button to switch the emergency
flashers on or off.
When the emergency flashers are turned on, the
Bland BJ indicator lights will flash at the same
time.
You can indicate a lane change or a turn when the
emergency flashers are switched on by using the
turn signal lever. The emergency flashers stop
temporarily.
The emergency flashers also work when the igni-
tion is turned off.
You should switch the emergency flashers on
53
>
OwnersManuals2.com