Audi Q4 e-tron 2024 - Page 275

89A0127218G.
Emergency assistance
—Jump start cables can cause considerable
damage to the vehicle electrical system if
they are connected incorrectly.
— You must not give a jump start with your ve-
hicle. This could cause significant damage
to the electrical system in your vehicle.
— There must be no contact between the
vehicles, or else voltage could flow when
connecting the positive terminal and drain
the
vehicle battery of the vehicle providing
the jump start.
~The drained vehicle battery must be con-
nected correctly to the electrical system.
— Switch off electrical equipment that is not
needed.
Jump starting
Both jump start cables must be connected in the
correct order.
Fig. 166 Front compartment: connectors for jump start ca-
bles or a charger
Fig. 167 Connecting the jump start cables
The jump start cables are located in the front
compartment.
Follow the information about the vehicle battery
= page 236.
Connecting the positive cable (red) to the
positive terminal
> Open the cover on the positive terminal
fig. 166.
1. Attach one end of the positive cable (red) to
the jump-start pin @ ® fig. 167 on your vehi-
cle.
2. Attach the other end of the positive cable
(red) to the positive terminal @) on the pow-
er source.
Connecting the negative cable (black) to the
negative terminal
3. Attach one end of the negative cable (black)
to the negative terminal @) on the power
source.
4. Attach the other end of the negative cable
(black) to the jump-start pin @ on the vehi-
cle.
Establishing drive ready mode
» Start the engine in the vehicle giving the charge
and let it run at idle.
» Establish drive ready mode in your vehicle with
the drained vehicle battery.
» If drive ready mode cannot be established, stop
the procedure and try again after approximate-
ly one minute.
» Remove the cables in reverse order of the way
they were installed.
» Close the cover on the positive terminal.
» Immediately visit an authorized Audi dealer or
authorized Audi Service Facility to have the ve-
hicle battery checked.
— Never connect the jump start cable directly
to your vehicle battery. Only use the connec-
tions in the front compartment.
— Do not touch the non-insulated parts of the
terminal clamps. The cable must also not
come into contact with vehicle components
that conduct electricity when it is connected
to the positive vehicle battery terminal. This
can cause a short circuit.
273
OwnersManuals2.com