Audi Q5 2009 - Adjusting Seating Positions; Seat Adjustment Controls; Headrest Adjustment and Safety

Audi Q5 2009 
No. 66, Body, Edition 11.08
3 Partition grid assembly set
5
6
3 Partition grid assembly set
The luggage compartment cover and net partition cannot be
used when the partition grid is installed.
– Check that the assembly set is complete.
– Remove the net partition (if present).
– Remove the luggage compartment cover and fold down
the rear backrest.
– Screw the retaining clamp -9- loosely to the pin -7-, rubber
washer -8- and star grip nut -10-.
– As shown, press the pin of the retaining clamp up into the
cut out (large drilled hole in the roof) -Arrow A-.
– Now move the retaining clamp up slightly and in the
direction of travel -Arrow B-, until the pin hooks into the
small hole.
– Tighten the star grip nut slightly. The upper retaining clamp
must still be moveable.
– Insert the partition grid - tilted slightly as shown - carefully
through the luggage compartment and position roughly in
the installation position.
Note
ZUB-0123
10
9
8
7
A
B
9
ZUB-0097
10
7
ZUB-0098