• ..__ H_o_m_ e_L_i_n_k_@_R __________________________________________________ _
Ap pli es to vehicles: with Home li nk® universal remote contro l
Programming the Homelink ® tr a nsmitt e r
The transmitter is programmed in two phases. For rolling
code transmitters, a third phase is also necessary.
............ ,
i
········
··:-:-:•
•••••••
l ·=·····
i---·~·
11111
0
N
s
ti
IX)
IX)
Fig . 153 Overhead
console: HomeLink®
keypad
Fig. 154 Radiator
grille : location of trans-
mitter unit
Phase 1: programming the overhead keypad
1. Make sure your vehicle is within operating range of the
remote controlled garage door opener .
2. Set the parking brake =>
& in "General information" on
page 141.
3. Turn the ignition on. Do not start the engine!
4. Press and hold the two outside Homelink® buttons
(D
and @ tor approximately 20 seconds until indicator
light @ => fig.
153 begins to flash. Then release both
buttons. Do not hold the buttons for longer than
30
seconds.
This procedure only needs to be performed
once. It
erases the factory-set default codes and does not have to
be repeated to program additional remote controls.
5. Press and hold the Homelink® button
(D, ® or @ until
the indicator light @ starts flashing
slowly. Release the
button.
- The system will remain in programming mode for 5
minutes.
Go to the front of the vehicle and proceed with
phase 2.
Phase 2: at the radiator grille
6. Point the original remote control to the middle of the
radiator grille of your vehicle => fig.
154 .
7. Hold the original remote control at a distance between 0-
6 in. (0-15 cm) (use the shortest distance possible).
8. Press and hold the activation button on the remote
control.
- May be different in Canada. If so, press and re-press
(cycle) the activation button on your remote control every
two seconds.
9. The emergency flashers will flash
three times (after
about
15- 60 seconds) when the programming is
successful. Release the button on the remote control.
- To program more devices, repeat steps 4 to 9.
To Next Page
Loading...
